VeriFone P400 PLUS - Entering System Mode

SYSTEM MODE
Entering System Mode
P200/P400 R
EFERENCE GUIDE 21
Entering System
Mode
With an application loaded, use the following procedure to enter System Mode.
Accessing System
Mode
To enter System Mode:
1 Press the '1', '5', '9' keys at the same time.
2 Select preferred login.
Figure 5 System Mode Login Screen
• Supervisor: Full capability
• Level 1: User defined capability
• Level 2: User defined capability
• Maintenance: Intended for Verifone repair, allows minimal access
3 Once the login has been selected, enter the password. If the password is pre-
expired or is pending change the user must enter the current password and
then a new password (pre-defined in the case of a pending password change).
The new password must be entered twice for validation. The default System
Mode password is:166831.
NOTE
Before entering System Mode and selecting the function(s) to perform, verify that
the unit has been installed as described in P400/P400 Plus Installation Guide,
VPN - DOC435-003-EN or P200/P200 Plus Installation Guide, VPN -
DOC430-003-EN. Make sure that the unit is connected to a power source and is
turned on.
supervisor
level1
level2
maintenance
Users (Prod)
NOTE
A special menu can be accessed by pressing the Cancel key — Reboot, Run
Apps, Transfer Logs, and System Info can be accessed without logging in or
entering any password.