Revision History
Updated format, Added
Install note regarding Extra
Signature Copy
Changes made to PINpad
setup
Updated links to Datacap
Software
Adding Pre-Auth and Post-
Auth behavior with Fine
Dining
Installation notes:
The merchant is responsible for contacting their Reseller and obtaining a Merchant Number, as well as
having a Deployment ID created on DataCap’s PSCS Server prior to installation.
You must be running CRE/RPE version 12.70130 or higher to use this device. To install the required
version of CRE/RPE Windows 7 or above is required.
In order to process EBT transactions you be running CRE/RPE version 12.8013 or higher.
The click here for the pinpad’s supported application load for version supported by DataCap & First
Data Rapid Connect.
Gift card processing is NOT supported at this time.
The NETePay software only needs to be installed on 1 station which will act as the DataCap server.
It is recommended to install the NETePay Software on a back office computer that can act as a server.
The VX 805 driver, dsiPDCX software, and dsiEMVUS software needs to be installed on each station
that will process card payments.
A settlement command (manual settlement or auto settlement set in CRE/RPE) CANNOT be sent to the
processor from CRE/RPE. The settlement must be set to auto settle through the processor.
Device encryption is configured by the processor prior to deployment.
As of version 12.8023 and newer, the receipt option Suppress Extra Signature Copy is unavailable due
to requirements of the Datacap Platform
As of version 12.8031 and newer, the steps for selecting the PINpad and payment processor have been
moved to the same screen within the payment processing setup.
As of Version 12.9019 and newer, the ability to add tips. Tip Adjustment is not supported by DataCap
FD Integration.
Bar Tab isn’t support by Datacap FD Integration.
To Next Page
Loading...
Need help?
General
