6161
Machine Setup
EN
10. Lower the presser foot lifter.
11. Pull down the lever to the very bottom.
When heard a "click" sound, it will be
on the right position to do the needle
threading and the hook pin passes
through the needle eye.
①
Lever
②
Hook pin
③
Needle
12. Pass the thread around the thread guide.
Take the thread in front of the needle and
make sure it is under the hook pin.
①
Thread guide
②
Hook pin
13. To cut the excess thread, take thread end
and gently slip it over the thread cutter
located on the right of the needle.
①
Thread cutter
14. Raise the lever, the hook will rotate and
pass the thread through the needle eye to
form a loop.
Pull the thread through the needle eye to
nish threading.
Note
Your machine is threaded and ready for
sewing, follow the instructions on "Starting
to sew" chapter to start sewing.
2
3
1
1
2
1
To Next Page
