80
Embroidery Preparation
Place the inner hoop on the fabric and press
rmly until them are securely t to outer hoop
perfectly. If the inner hoop cannot t properly,
loosen the outer hoop's fastening screw and
adjust until tted.
When the fabric and inner hoop are
completely t into the outer hoop, pull the
fabric from the four sides marked with the
arrows so that the fabric is stretched drum-
tight in the hoop, and then press the inner
hoop downwards so that it sinks into the outer
hoop a little and tighten the fastening screw.
①
Fastening screw
v
Use the quick release device
If same type of fabric is used for embroidery,
open the quick release device under the outer
hoop.
Separate the inner hoop and outer hoop.
①
Quick release device
Place the inner hoop on the fabric and press
rmly until them are securely t to outer hoop
perfectly, pull the fabric from the four sides
marked with the arrows so that the fabric is
stretched drum-tight in the hoop, and then
press the inner hoop downwards so that it
sinks into the outer hoop a little and close the
quick release device.
1
1
1
To Next Page
Loading...
