EasyManuals Logo

Vertex Standard VX-110 User Manual

Vertex Standard VX-110
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
Specifications
GENERAL
Frequency coverage (MHz): 144 to 147.995 (version A)
144 to 145.995 (version B)
Channel steps: 5, 10, 12.5, 15, 20, 25 & 50 kHz
Standard repeater shift: 600 kHz
Emission type: G3E
Supply voltage: 6.0 to 16.0 VDC
Current consumption: Receive: 130 mA;
Transmit (HIGH:5W) : 1.3 A;
(MID:2 W) : 800 mA;
(LOW:0.5 W) : 500 mA;
Auto Power Off : 8 mA
Antenna (BNC jack): YHA-62 rubber flex antenna
Case size (WHD): 58 (W) x 108.5 (H) x 26.5 (D) mm (w/o knob & antenna)
Weight (approx.): 325g w/FNB-64 & antenna
RECEIVER
Circuit type: Double-conversion superheterodyne
Sensitivity (for 12dB SINAD): better than 0.16µV
Adjacent channel selectivity: better than 70 dB
Intermodulation: better than 70 dB
Audio output: 0.4 W @8 ohms for 10% THD (@7.2V)
TRANSMITTER
Power output: 5 W (@ 7.2 V & 13.8 V EXT DC IN)
Frequency stability: better than ±5 ppm
Modulation system: variable reactance
Maximum deviation: ±5 kHz
Spurious emissions: better than 60 dB below carrier
Audio distortion (@ 1 kHz): less than 5 %, w/3 kHz deviation
Microphone type: 2-kilohm condenser
Burst tone: 1750 Hz (except version A)
Specifications may be subject to change without notice or obligation.
37
1. Changes or modifications to this device not expressly approved by Yaesu Musen could void
the user’s authorization to operate this device.
2. This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions; (1) this device may not cause harmful interference, and (2) this device must accept
any interference including interference that may cause undesired operation.
3. The scanning receiver in this equipment is incapable of tuning, or readily being altered, by the
User to operate within the frequency bands allocated to the Domestic public Cellular
Telecommunications Service in Part 22.
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two
conditions; (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesirable operation of the device.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vertex Standard VX-110 and is the answer not in the manual?

Vertex Standard VX-110 Specifications

General IconGeneral
BrandVertex Standard
ModelVX-110
CategoryTransceiver
LanguageEnglish

Related product manuals