VX-110 OPERATING MANUAL 13
TRANSMITTER TIME-OUT TIMER
(
TOT
)
The TOT feature provides a safety switch which limits transmission to a pre-programmed
value. This will promote battery conservation by not allowing you to make excessively-
long transmissions, and in the event of a stuck PTT switch (perhaps if the radio or a Speaker/
Mic is wedged between car seats) it can prevent interference to other users as well as
battery depletion. As configured at the factory the TOT feature is set to OFF, and here is
the procedure for activating it:
Press the
[
F
]
key, then press the
[
M/V
(
SET
)
]
key to enter the Set mode.
Rotate the DIAL to select Menu Item #20 (“TOT”).
Press the
[
F
]
key to enable adjustment of this Menu item.
Rotate the DIAL to set the Time-Out Timer to the desired “Maximum TX” time (1
minute, 2.5 minutes, 5 minutes, or 10 minutes).
Once you’ve made the selection you wish to use, press the PTT key to save the new
setting and exit to normal operation.
ANI OPERATION
(
AUTOMATIC NUMBER IDENTIFICATION
)
When you activate the ANI feature, the DTMF tones stored in ANI memory will automati-
cally be sent whenever you press the PTT button.
Here is the ANI storage procedure:
Press the
[
F
]
key, then press the
[
M/V
(
SET
)]
key, to enter the Set mode.
Rotate the DIAL to select Menu #34 (“ANI”).
Press the
[
F
]
key to enable changing of this Menu item.
Press the
[
F
]
key, then press the
[
F
]
key again, to begin entry of the letters and numbers
in the ANI code.
Rotate the DIAL to select the first letter or number in the ANI code. When the correct
character has been selected, press the
[
s
]
key to move on to the next character.
Repeat step
as many times as necessary to complete the ANI code.
When you have completed entry of the ANI code, press the
[
F
]
key.
Press the PTT key to save the settings and exit to normal operation.
To activate the ANI identifier:
Press the
[
F
]
key, then press the
[
M/V
(
SET
)]
key, to enter the Set mode.
Rotate the DIAL to select Menu #34 (“ANI”).
Press the
[
F
]
key to enable changing of this Menu item.
Rotate the DIAL to set the ANI function ON.
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.
Advanced Operation
To Next Page
Loading...
Need help?
General
