Vertex Standard VX-150 - Page 37

VX-150 OPERATING MANUAL 35
Set Mode
Set Item 17
[
EDGE BP
]
Function: Enable/disable the Band-edge beeper while scanning.
Available Values: ON/OFF
Default: ON
Set Item 18
[
BELL
]
Function: Select the number of CTCSS Bell ringer repetitions.
Available Values: OFF/1/3/5/8/REPEAT
Default: OFF
Set Item 19
[
MON/TCL
]
Function: Select the MONI key (just below the PTT switch) function.
Available Values: MONI/T.CALL
Default: Depends on the transceiver version.
MONI: Pressing the MONI key causes the noise/tone Squelch to be over-ridden, allow-
ing you to listen for weak (or non-encoded) signals.
T.CALL: Pressing the MONI key activates a 1750-Hz burst tone, used for repeater access
in many countries.
Set Item 20
[
REV/HM
]
Function: Select the function of the
[
REV
(
HM
)]
key.
Available Values: REV/HOME
Default: REV
Set Item 21
[
LMP MOD
]
Function: Select the LCD/Keypad Lamp mode.
Available Values: KEY/5SEC/TOGGLE
Default: KEY
Set Item 22
[
TOT
]
Function: Set the TOT (Time-Out Timer) time.
Available Values: OFF/1 min/2.5 min/5 min/10 min
Default: OFF
Set Item 23
[
BCLO
]
Function: Enable/disable the Busy Channel Lock-Out feature.
Available Values: ON/OFF
Default: OFF