Vertex Standard VX-264 - TA (Talk Around) Scan; Talk Around; Reset Function

24
VX-264 Operating Manual
ta
(
talK around
)
scan
Press,(orpressandhold),theassigned
PF
keytotoggle
theTAScanfeature“On”and“Off”.
Whenoperatingonaduplexchannelsystem(forexample,
a repeater station), TA Scan allows the transceiver to
searchbothtransmitandreceivefrequenciesonyourdu-
plexsystem.
When asignal is encountered on the receive frequency,
the transceiver will pause until the signal disappears.
When asignal isencountered onthetransmit frequency,
thetransceiver willcheckforactivity onthereceive fre-
quencyeveryfewseconds(intervalprogrammedbyyour
VertexStandarddealer).
WhentheTAScanfeatureisactivated,the“ ”iconwill
blinkonthedisplay(Seepage11inthismanual).
Note:TheTAScanfeaturedoesnotactivateonaSimplex
Channel.
talK around
Press,(orpressandhold),theassigned
PF
keytoactivate
theTalkAroundfeaturewhenyouareoperatingonduplex
channel systems (separate receive and transmit frequen-
cies, utilizing a “repeater” station). TheTalkAround
featureallowsyoutobypasstherepeaterstationandtalk
directlytoastationthatisnearby.Thisfeaturehasnoef-
fectwhenyouareoperatingon“simplex”channels,where
thereceiveandtransmitfrequenciesarealreadythesame.
WhentheTalkAroundfeatureisactivated,the“ ”icon
willbeindicatedonthedisplay(Seepage11inthisman-
ual).
Notethatyourdealermayhavemodeprovisionfor“Talk
Around” channelsby programming“repeater” and“Talk
Around”frequenciesontwoadjacentchannels.Ifso,the
key may be used for one of the other Pre-Programmed
Functions.
Note:TheTalkAroundfeaturedoesnotactivateonaSim-
plexChannel.
reset
Press(orpressandhold)theassigned
PF
keytoresetthe
RFC(ReadyforCommunication)condition.
adVanced oPeration