Vertex Standard VX-264 - Follow Me Scan; Scan Set

VX-264 Operating Manual
23
adVanced oPeration
FolloW me scan
The FollowMe Scanfeature checksa user-assigned pri-
ority channel inaddition to the channelspreviously pre-
programmedintoaradio’sscanlist.Forexample,ifonly
Channels 1, 3, and 5 (of the 8 available channels) are
designatedfor“Scanning”,theusermayassignChannel2
asthe“user-assigned”prioritychannelviatheFollowMe
Scan.
ToactivateFollowMeScan, rstselectthechannelyou
want to designate as the “user-assigned priority chan-
nel”by positioningthe
CH
Selector knobonthedesired
“priority” channel. Next, press, (or press and hold), the
assigned
PF
key (thedisplay willindicate “”
briefly). Finally, rotate the
CH
 Selector knob to the de-
sired“operatingchannel”.
The scanner will search thetwo channels (user-assigned
prioritychannelandoperatingchannel)andpausewhenit
ndsatransmissiononeitherchannel.
scan set
Press,(orpressandhold),theassigned
PF
keytoadd/de-
letethecurrentchannelto/fromyourscanninglist.
Tostoreaparticularchanneltoyourscanninglist,press,(or
pressandhold),theassigned
PF
key.Ifyoudeleteachan-
nelfromyourscanninglist,press,(orpressandhold),the
assigned
PF
keyagain.
Whenthescannerispaused,youmayremovethechannel
from thescan listtemporarily by pressing,(or press and
holding),thesamekey.
Note 1:whenstoreaparticularchanneltoyourscanning
list,thedisplayindicates“”brieyand“ ”icon
willappearonthedisplay.
Note 2:whendeleteachannelfromyourscanninglist,the
display indicates “ ” briey and the “ ”icon
willdisappearfromthedisplay.
Note 3: To reset your scan list to it’s original pre-pro-
grammedsettings, powerthe transceiveroff,thenon us-
ingthe
VOL/PWR
knob.