Vertex SR Series - Page 10

- 10 -
CHAPTER 2: Basics
Installing Your Illumina SR
Next, take the bare end of the cable and thread it through the eye-hole of the male end of the Socket
Anchor.Pullituntilthecableisfullythreadedthroughthettingasshown.Thestopperwillholdonceit
reachestheeye-holeofthetting.
Now take the cable and thread it through the Cable Clamp. It will push out from the side wedge of the
ttingandcanbepulledthroughfromthere.Continuetopullthecablethroughthetting.Donotworry
if you draw too much length, as this can later be adjusted.
You can use the central channel to hide any excess cable.