Vertex SR Series - Installing and Suspending the Illumina

- 9 -
CHAPTER 2: Basics
Installing Your Illumina SR
Please read the following instructions thoroughly and consult with an expert before installing your Il-
lumina.Thextureshouldalwaysbelocatedaboveyourdisplayinawell-ventilatedspaceandshould
not be touching any surfaces once suspended. Locate the unit away from areas of high humidity and/
or water and salt spray. The manual explains the installation with the optional Suspension kit, for the
Mounting Braket see the manual which is coming with the Braket.
Assembling the Suspension Kit (optional)
Locate the rubber O-rings and loop them over each of the threaded ends of the Cable Clamps.
TakeeachCableClampandinstalltotheIlluminaxturebythreadingtheboltsthroughtheadjustable
suspensionbridgesfoundinthecenterchannelofthexture.Hand-tightenonly.
Cables (optional)
Begin by noting the two different ends of the steel ca-
bles. One end will have steel bolt. This is the stopper
end and it goes anchor-side. The other will be a bare
line. This end threads through the cable clamp and is
xture-side.
At this point, do not attempt to trim/shorten or crimp
any of the cables.