Vertical Edge 120 - Speed Dial; Operation - Setup

Edge 120 Digital Executive Telephone User Guide Page 15
Saved Number Redial FEATURE 
Saved Number Redial is normally used whenever you want to retain a
telephone number to be dialed later. The same feature code is used to
Save a Dialed Number (SDN) and to dial the saved number – Saved
Number Redial (SNR).
Operation – SDN
1. After you’ve placed an outside line call for which you want to
store the number, press FEATURE
.
2. The dialed number is stored in the Saved Number memory.
Operation – SNR
1. When the telephone is idle, press the FEATURE button
designated as REDIAL (if available) or press FEATURE
.
2. The stored number is dialed.
Speed Dial Extension  – 
System  – 
Speed Dialing allows you to store frequently dialed numbers. There
are 20 speed “bins” for most extensions and 200 system speed bins
that may be shared by all extensions.
Operation – Setup
1. Press FEATURE .
2. Dial the Speed Dial location number (
 – ).
3. Press [show]. The current contents are displayed.
4. Press [chg].
5. Input the number you want to store, including Pauses (FEATURE
), Flash FEATURE  and Pulse To Tone Conversion ()
codes.
6. Press [save]. That number is stored in this speed dial location.
7. Continue programming speed dial locations from step 2 above or
hang-up (press SPK twice) to exit.