Vertiv Liebert GXT4-2000RT120 - Page 32

FACTORY DEFAULT screen
Select MAIN MENU > 2 CONFIGURATION > 7 FACTORY DEFAULT to enter the FACTORY DEFAULT
screen.
Control Screen
Select MAIN MENU > 3 CONTROL to enter the CONTROL screen. This screen has three sub menus,
TURN ON & OFF, ALARM CONTROL and BATT TEST.
In the CONTROL screen, press the Up or Down button to move the cursor to the required item, and
press the Enter button to enter its sub menu.
TURN ON & OFF screen
Select MAIN MENU -> 3 CONTROL -> 1 TURN ON & OFF to enter the TURN ON & OFF screen. This
screen shows one of two displays, TURN ON UPS and TURN OFF UPS, depending on the state of the
UPS.
ALARM CONTROL screen
Select MAIN MENU -> 3 CONTROL -> 2 ALARM CONTROL to enter the ALARM CONTROL screen.
This section allows active audible alarms to be silenced.
To completely turn off the audible alarm, select CONFIGURATION > UPS.
BATT TEST screen
Select MAIN MENU -> 3 CONTROL -> 3 BATT TEST to enter the BATT TEST screen.
Log Screen
Select MAIN MENU -> 4 LOG to enter the LOG screen. This screen has two submenus, VIEW LOG
and CLEAR LOG.
CLEAR LOG Screen
Select MAIN MENU > LOG > CLEAR LOG to enter the CLEAR LOG screen.
Press the Up or Down button to move the cursor to the required item. Press the Enter button to
confirm the settings.
ABOUT Screen
Select MAIN MENU> ABOUT to enter the ABOUT screen. The ABOUT screen displays UPS model,
serial number, software version and hardware version.
Network
Select MAIN MENU > NETWORK to enter the NETWORK screen.
The NETWORK screen displays the MAC address and the IPv4 IP address. If the GXT4 is fitted with
an optional Liebert® IntelliSlot Web card (Liebert IS-WEBCARD), the screen will display IPv6 IP
address settings (IPv6 requires configuration).
Vertiv | Liebert® GXT4™ Installer/User Guide
32