Vertiv | +24 VDC Power System User Manual (Section 6013) | Rev. G
NOTES
Only active alarms are displayed.
Subsystem alarms are not displayed if no subsystem is installed.
Low voltage disconnect alarms are not displayed if no LVDs are installed.
Only installed Rectifier Modules (PCUs) are displayed.
Only installed SYS LOADs are displayed.
Only installed SUB LOADs are displayed.
Only installed LVDs are displayed.
Subsystem entries are not displayed if no subsystem is installed.
Low voltage disconnect entries are not displayed if no LVDs are installed.
The "Adjust LVD" entry is not displayed if no LVDs are installed.
The "CAL SUB" entry is not displayed if no subsystem is installed.
The "RESTORE MFG CAL" entry is displayed only if "CAL SYS" or "CAL SUB" has been changed from its default.
To Next Page
Loading...
