DGT / DGT60 / DGTQ / DGTP
54
IntES PRINTING OF HEADING
Int no no heading.
Int Si prints the heading; in the totalizer mode it is printed only upon the first totalisation (in other
words if the partial total is zero).
Int Fi prints the heading; in the totalizer mode it is printed in all the totalisations.
Int.SuM prints the heading; in the totalizer mode it is printed in all the totalisations and in the partial
total.
(!) Int no
nuMWEi PRINTING OF NUMBER OF WEIGHS (ONLY FOR TOTALIZER MODE)
no does not print the number of weighs.
tot prints the number of weighs only in the single totalisation.
Sum prints the number of weighs only in the partial total.
both prints the number of weighs in the totalisations as well as in the partial total.
NOTE: the parameter is displayed only if the "totalizer" functioning mode has been selected.
(!) both
dOM PRINTS DATE AND TIME
dt. no the date and time are not printed.
dt.in.1 the date and time are printed using the clock inside the printer; in the totalizer functioning
mode the date and time are printed just in the total and not in the single totalizations
dt.in.2 as above, but in the totalizer functioning mode the date and time are printed also in the
single totalizations.
dt.EX.1 like "dt.in.1" but the indicator’s date and time board (optional) is used.
dt.EX.2 like "dt.in.2" but the indicator’s date and time board (optional) is used.
NOTE: The date and time is printed, if programmed, before the possible barcode, which is always at the
end of the printout
(!) dt. No
ntik PRINTS TICKET NUMBER
The ticket number is a sequence number which increases upon each printing made, this number,
between 1 and 65535, is kept in memory also when the instrument is turned off.
no does not print the ticket number.
yes.tot prints the ticket number; in the totalizer functioning mode it is printed only in the single
totalisations.
SuM prints the ticket number; in the totalizer functioning mode it is printed just in the partial total.
both prints the ticket number; in the totalizer functioning mode it is printed in the totalisations as
well as in the partial total.
rESEt by pressing PRINT the sequence number in the ticket is zeroed.
NOTE: The ticket number, if programmed, is printed after the weight data.
(!) no
EndPAG SELECTION OF PAGE END PRINTING
This step allows to print 2 empty lines at the end of each printout (if "DP190" is selected in the "PrModE"
step) or an end label (if "LP542" is selected in the "PrModE step).
no does not print the page end
yes.tot prints the end page; in the totalizer functioning mode it is printed just in the single totalisations.
SuM prints the end page; in the totalizer functioning mode it is printed just in the partial total.
both prints the end page; in the totalizer functioning mode it is printed in the totalisations as well as
in the partial total.
(!) yes.tot
To Next Page
Loading...