DGT / DGT60 / DGTQ / DGTP
62
!! IMPORTANT !!
8.2 SAVING THE LABEL IN THE LABELLER’S PERMANENT MEMORY
Once the programming of the label has made, one should:
1. Download the label created in the labeller press PRINT when the display shows the "doWnLd" step.
2. Press the C - ON/OFF key; the display shows the message "L.SAVE?": press the PRINT key to save the
label created in the labeller’s permanent memory.
When saving the data on the labeller, the green led blinks; while this happens do not do anything with the
indicator or the labeller.
The saving of the label ends when the led stops blinking.
The labeller has the label saved and is ready to print it; turning off the labeller does not cause the loss of the
saved data.
REPEAT THESE SAVING OPERATIONS EACH TIME THAT ONE MODIFIES THE LABEL OR THE DATA
IN IT OR IF IT IS NECESSARY TO CHANGE THE FUNCTIONING MODE AFTER HAVING PROGRAMMED
THE LABEL.
It is also possible to create or customize the label, by using the label creation programme supplied together
with the labeller; refer to the labeller manual for further information.
To Next Page
Loading...