3.Paper deviation occurred during cutting.
Solution: Because the tension of paper press is inconsistent, rotate
the two yellow copper nuts on each paper press to the same height,
then the pressure is balanced, as shown below:
Rotate to the same height
4.The effect of small graphics cutting is not ideal.
Solution: When the cutting height is 3-5 mm letters, the software
compensation value is set to 0.45 and the speed is adjusted to
400mm/s. When the cutting height is more than 5 mm letters, the
software compensation value is set to 0.3 and the speed is adjusted
to 600mm/s or more.
Cutting height for 3-5 mm
compensation Settings
Cutting height is more than
5mm compensation setting
To Next Page
Loading...
