VEVOR LB200T - Daily Cleaning and Maintenance Procedures; Ice Thickness Setting Reference

- 13 -
8.fault codes
E-01.ice full button falut, skate board not back in position properly or ice full
button damage
E-02.making ice over time,can’t detect ice thickness 5 times continuously
E-03.unload ice over time,can’t detect ice full button action within 6mintues
unload ice 3times continuously
E-04.high temperature fault,condensation temperature higher than setting
temperature
E-05.lack of water
E-06.high pressure
E-07.condensation sensor fault
ICE THICKNESS SETTING TIME REFERENCE LIST
Ambient Temperature
Ice-Shedding Time
10
℃
～20
℃
12min～15min
20℃～32℃
15min～18min
32℃～35℃
18min～22min
35℃～43℃
22min～26min
Note: The above data is for reference only. Different regions and different
environments may have differences.
DAILY CLEANING AND MAINTENANCE
1. Clearance of side panels and inner container
A、Before cleaning and sanitizing the ice maker, cleaning up the ice blocks