VEVOR MCS1000 - Page 27

- 26 -
Operation instructions
A T T E N T I O N
Never switch the machine on while pressing the chisel against the
material!
N O T I C E

Before switching the machine on, make sure that the tool rest is
firmly tightened

Rotate the clamped workpiece each time before turning by hand to
ensure that it runs freely and does not touch the rest tool!

Thereby check also whether the workpiece is centred and tighten
clamped!

Make sure to guide and hold the chisel with both hands safe and
tight during machining!

Work only with well sharpened tools!

Work large and unbalanced workpieces at low spindle speed only!

Specifications regarding the maximum or minimum size of the
workpiece must be observed!

Workpieces with cracks may not be used!

Only process selected woods without defects!
Operation
On-Off-switch
Switch on: Push the green button ("I") for 2 seconds. The machine begins
to run.
Switch off: Push the red button ("0").
The machine does not stop immediately! Stay as long at the machine, until
the workpiece is completely stopped (Do not stop the workpiece by hand!)