The MX-S716G Lathe is rated at 800W. Confirm power available at the
lathe' s location is the same rating as the lathe. Using the wiring diagram
for connecting the lathe to the mains supply. Make sure the lathe is
properly grounded.
Keep maintenance of the machine tool during the operation to guarantee
the accuracy and service life of the machine tool.
1. In order to retain the machine's precision and functionality. It is essential
to treat it with care. Keep it clean and grease and lubricate it regularly. Only
through good care. You can be sure that the working quality of the machine
will remain constant.
NOTES: Disconnect the machine plug from the mains supply whenever
you carry out cleaning, maintenance or repair work!
Oil, grease and cleaning agents are pollutants and must not be disposed of
through the drains or in normal refuse. Dispose of those agents in
accordance with current legal requirements on the environment. Cleaning
rags impregnated with oil, grease and cleaning agents are easily
inflammable. Collect cleaning rags or cleaning wool in a suitable closed
vessel and dispose of them in an environmentally sound way - do not put
them with normal refuse!
2. Lubrication all slide ways lightly before every use. The change gears and
the lead screw must also be lightly lubricated with grease.
3. During the operation, the chips which fall onto the sliding surface should
be cleaned timely, and the inspection should be often made to prevent
chips from falling into the position between the machine tool saddle and
lathe bed guideway. Asphalt felt should be cleaned at a certain time.
NOTES: Do not remove the chips with your bare hands. There is a risk of
To Next Page
Loading...
