1.Raw Material Preparation
According to the manufacturer's operating instructions, dilute the concen-
trate with water and stir in a suitable container. The mixture contains sugars ,
the amount of which should be kept between 13%-18%. Lower and higher
concentrations can be destroyed agitators and stirring motors.
2.Raw Material Filling
Before adding the raw materials, t to ensure that there is no residual moisture
in the freezing tank during cleaning. Check the discharge valve assembly,
whether it is installed in place, and whether the four fastening nuts are twisted.
Inject about 6 liters of slush raw material into the material tank,
(The single-tank slushy machine can pour up to about 10 liters of raw material
into the material tank.)
Each freezing tank of this machine is equipped with an independent stirring
system, and the system can act independently on one side.
materials
3.Sta The Machine
Refer to the operating instructions
Note: When the machine is in working condition, do
not put your ngers into the feed bowl raw material
supply po. Failure to do so may result in nger inju-
ries or machine malfunction.
switch
operation panel
4.Make Smoothies
When the shape ratio reaches 99% and the machine is
automatically stopped, it means that the smoothie is
ready. Simply pull the handle down to punch out the
smoothie.
close
open
cup
12
Slush Production
To Next Page
Loading...
