1. Do not place items on the top cover of this machine, otherwise it will cause noise.
2. The left, right and rear sides of the machine must have sucient heat dissipation space, otherwise
it will aect the heat dissipation, and the production capacity of the machine aected by the
air-cooled circulation channel, and it is forbidden to place items around.
3. The slushy machine should be kept away from the heat source, it is strictly forbidden to use it in a
high or low temperature environment, and the direct sunlight should be avoided as much as possible
so as not to aect the heat dissipation of the machine.
4. Sterilization should be carried out daily. Otherwise, bacterial multiplication can be detrimental to
health.
5. If the slushy machine is placed for a long time, please disassemble and wash it, turn o the power
plug, please carefully d the water of the material tank and the freezing tank; after they are dried
and then covered with the material basin cover for safekeeping.
Proper Operation When Using
07
Names of Each Pa
Pre-boot Inspection
1. Is the slushy machine placed horizontally?
2. Is there any problem with the power outlet?
3. Whether the access to the power supply is consistent with the one marked on the machine
nameplate.
Hopper cover
Liquid level oat
Material tank
Display screen
Tie rod holder
Tie rod
Freezing cylinder
Magnetic light box
Power switch
Handle
Handle cross pin
Fastening nut
Beater assembly
Machine foot
Residual material po
Water box
Discharge valve
assembly
To Next Page
Loading...
