VEVOR XRJF-21 - Noise and Smoothie Issues

19
The machine is noisy when pressing the
cleaning key
The cleaning noise will gradually reduce
after adding raw materials
The machine is noisy when cooling
The ground on which the machine is placed
is not horizontal, adjust by yourself
Fan noise
The noise will be reduced gradually after
adding material when there is a lack of
material.
Motor noise
The gear setting is too high, adjust the gear
by yourself
Compressor noise
Abnormal noise
after power on
6
Self-check whether there are foreign
objects around the fan blades and whether
the xing screws of fan bracket are loose
Check whether the wind blade rubs the
nest shell when rotating
Check whether the xing screws of
condenser are loose
Noise generated by too high gear setting
Noise of the motor itself
The xing screws of motor are loose
Condenser has not been cleaned for a
long time, the condenser is too diy
resulting in excessive compressor load
Internal piping deformation causes
vibration noise
Compressor normal noise
7
Smoothie
discharges are
too soft or too
little
Too frequent discharge
Wait until the molding ratio reaches 90% or
more before mixing the material
Poor heat dissipation
Solve the problem of ventilation on both
sides of the machine, leave at least one
meter of space on both sides
Not enough gears Adjusting gears
Machine cooling system failure Refrigerant leakage or compressor failure
8
No smoothie or
too soft after
stopping the
machine
The beating handle is not in place
When the handle does not hit downward,
the beater switch is not closed and the
machine does not sta
The rst cup is softer after stopping the
machine
Sta after a long shutdown, it's normal for
the rst cup to be softer
Gear setting too high or too low Proper gear adjustment
Downtime setting is too long Appropriate adjustment of downtime
Discharge micro switch failure Replacement of discharge micro switch
9
Machine LL
Alarm
Sensing anomalies
Check if there are magnets on the motor or
adjust the speed sensor position or replace
Long buzzer sound, the whole machine
stops working
Check if the sensor is out of position or the
connection wire is disconnected