BIOS Setup
3-9
LS120 The system will boot from LS-120 drive.
HDD-0 The system will boot from first HDD.
SCSI The system will boot from SCSI.
CD-ROM The system will boot from CD-ROM.
HDD-1 The system will boot from second HDD.
HDD-2 The system will boot from third HDD.
HDD-3 The system will boot from fourth HDD.
ZIP100 The system will boot from ATAPI ZIP drive.
USB-FDD The system will boot from USB floppy drive.
USB-ZIP The system will boot from USB ZIP drive.
USB-CDROM The system will boot from USB CD-ROM.
USB-HDD The system will boot from USB HDD drive.
LAN The system will boot from network drive.
Disabled Disable this sequence.
Boot Other Device
Enable the system to boot from other devices if the system fails to
boot from the First/Second/Third boot device. Settings: Enabled and
Disabled.
Boot Up NumLock Status
Set the NumLock status when the system is powered on. “On” will
turn key pad into number keys, and “Off” will turn key pad into arrow
keys. Settings: On and Off.
Gate A20 Option
Set the Gate A20 option. Settings: Normal and Fast.
Typematic Rate Setting
Set the typematic rate and delay. Settings: Enabled and Disabled.
Typematic Rate (Chars/Sec)
When Typematic Rate Setting is enabled. This item allows you to
set the rate (characters/second) at which the keys are accelerated.
Settings: 6, 8, 10, 12, 15, 20, 24 and 30.
Typematic Delay (Msec)
When Typematic Rate Setting is enabled. This item allows you to
select the delay between when the key was first pressed and when
the acceleration begins. Settings: 250, 500, 750 and 1000.
To Next Page
Loading...
Need help?
General
