Chapter 3
3-26
This section describes the BIOS configuration of the PCI bus system.
This section covers some very technical items and only experienced
users should make any changes to the default settings.
PNP OS Installed
When set to Yes, BIOS will only initialize the PnP cards used for
booting (VGA, IDE, SCSI). Other cards will be initialized by the PnP
operating system like Windows
®
95 or 98/98SE. When set to No,
BIOS will initialize all the PnP cards. Set to Yes the operating system
is Plug & Play capable. The settings: No and Yes.
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset
Extended System Configuration Data (ESCD) when you exit Setup
if you have installed a new add-on and the system reconfiguration
has caused such a serious conflict that the operating system can
not boot. The settings: Enabled and Disabled.
PCI/VGA Palette Snoop
Set the PCI/VGA Palette Snoop option. Settings: Disabled and
Enabled.
Assign IRQ For VGA/USB
Assign IRQ for VGA and USB devices. Settings: Disabled and
Enabled.
PNP/PCI Configurations
To Next Page
Loading...
Need help?
General
