STEP 8. Voltage Offset Adjust Calibration:
Car engine stays off (ACC off), use multimeter to check car-battery
voltage from fuse box, and calibrate Power-PLUS by Voltage Offset
adjust setting.
Long press any button on Power-PLUS for 2 seconds to wakeup
from dot-blinking mode. Compare Power-PLUS meter display with
your multimeter voltage measuring, and then setup the offset value
for better accuracy in voltage-detection. For more detail, please
check the Voltage Offset Adjustment pages.
STEP 9. Connect Dash Cam.
Connect the Dash Cam Cigar Charger into the Power-PLUS Cigar
socket. And check if the Dash Cam operates normally or not.
STEP 10. Start Engine and Double-Check all your Car
Electric function:
Important!! Please carefully check ALL your car electric function,
including headlight, direction light, break light, hazard, radio…etc.
And check if there is any abnormal signal showing from your
dashboard display. Make sure it’s 100% working well before your
driving. Incorrect installation leads to damages and accidents.
STEP 7. Turn Main Switch into Activate to
check:
Car engine stays off (ACC off), and turn the
Power-PLUS Main Switch into “Activate”.
Power-PLUS LED display will show up “Batt” first,
and then entering dot cross-blinking display (due to
ACC off) afterwards, which is working properly.
English
16
Special Notice:
It’s commended to use extra tape to fix the connection between cigar
charger and Power-PLUS cigar socket, avoiding the detachment/loose
due to car vibration.
To Next Page
Loading...