14
OPERATING INSTRUCTIONS
Checking oil
The pressure washer is supplied without oil in the engine. Oil must be
added to the engine before rst use.
SAE 10W-30 standard engine oil is recommended for normal
operating conditions and temperature.
CAUTION
Checking the oil in the engine (Fig. 7)
a) Place the pressure washer on a at, level surface. Remove the oil/ller cap and wipe the
dipstick clean with a clean cloth.
b) Check the oil level by inserting the dipstick in the ller neck without screwing it in, then remove
it.
c) If the level is below the lower level line, add the oil until the level reaches the upper mark on
the dipstick.
d) Always ll the oil to the maximum level.
Fig. 7
To Next Page
Loading...