15
OPERATING INSTRUCTIONS
Adding fuel
CAUTION
USE FRESH UNLEADED FUEL (PETROL), 90 OCTANE OR
BETTER.
Do NOT use E10 or Ethanol blends as they can cause rusting of the
fuel tank.
WARNING
Move away from fuelling site before starting the pressure washer.
THE FUEL CAP HAS A VENT.
Overlling the fuel tank will result in
fuel leaking from the cap when the engine is started. This s a re
hazard.
a) Place the pressure washer on a at level surface.
b) Remove the fuel cap and strainer. Clean the strainer and replace it.
c) Fill the tank to the level of the shoulder on the fuel strainer.
DO NOT OVERFILL!
d) Clean up any fuel spills/splashes immediately. Wait 5 minutes for excess fuel to evaporate
before starting the engine and dispose of any fuel soaked rags properly.
e) After refuelling, replace the fuel tank cap tightly.
Fig. 8
To Next Page