17
OPERATING INSTRUCTIONS
Starting the pressure washer
WARNING
Before starting the pressure washer, make sure that the pressure washer is
completely assembled and all the hoses are properly connected.
WARNING
Make sure the pressure washer stands on at ground in a secure and stable
position.
WARNING
Hold the spray gun and the lance with both hands when using. Be aware of
the recoil.
CAUTION
Never operate the pressure washer without water as dry running may
damage the pump. Use a water lter if the water is contaminated.
CAUTION
Too high a pressure or holding the nozzle too close to the job may damage
the job's surface.
Before starting the engine, the high pressure pump must be primed.
a) Check that the water supply is turned on.
b) Unlock the trigger lock on the spray gun and press the spray gun trigger until there is a steady
stream of water from the nozzle. (Fig. 11)
Fig. 11
c) Move the fuel valve lever to the ON position. (Fig.12)
Fig. 12
To Next Page
Loading...