24
Cleaning the water filter
The pressure washer is equipped with a small water lter to protect the pump from debris
in the water supply. If the lter is not kept clean, the water ow to the pressure washer
will be restricted and may damage the pressure washer.
Note: The lter should be checked before each use.
a) To clean the water lter, remove the adapter at the water inlet to get access to the
lter.
b) Remove the water lter from behind the adapter at the water inlet.
c) Rinse the water lter until it is free of debris and blockage.
d) Replace the water lter and inlet adapter.
Cleaning nozzles
Clogging of the nozzle causes the pump pressure to be too high and must be cleaned
immediately.
a) Turn o the pressure washer and remove the clogged nozzle.
b) Clean the spray tips by carefully inserting the nozzle pin provided, or a thin and
sharp instrument into the tip to remove any dirt deposited.
Fig. 22
MAINTENANCE & CARE
To Next Page
Loading...