CAT III 600V and Grade II pollution. Before use,
please read this manual carefully.
1. When measuring the voltage above 30V, the AC
electric line with inductive loads and the AC electric
line during electric fluctuation, be cautious against
electric shock.
2. Before measurement, check if the measurement
function switch is at the proper gear, check if the test
probe touches the measured item reliably, with
proper connection, good insulation, etc, in order to
avoid electric shock.
3. The clamp multimeter cannot conform to the
requirements of the related safety standards until it is
used together with the attached test probe. If the test
probe cable is broken, it must be replaced with the
cable of the same type or the same electric
specifications.
4. Do not use any other batteries not confirmed or
unauthorized to replace the battery of the meter; do
replace the battery with only the battery of the same
type or the same electric specifications. Before
replacing the test probe, keep it away from the
To Next Page
Loading...
Need help?
General
