Input Impedance ： >10M Ω at Range 200mV
,
40M Ω at other Ranges 。
Overload Protection ： 600V AC or 600V AC Peak Value ；
2-3-2.
2-3-2.
2-3-2.
2-3-2.
ACV
ACV
ACV
ACV
1. Insert
the red
and
black
test leads
separately
to
and COM
input
mA
mA
mA
mA
V
V
V
V
terminals.
2.
Turn
the
knob
switch
to
Range,
press
“ SELECT ”
button
to
switch
to
ACV measurement
mode.
3.
This range
is
200mV,
The reading
to
measure the voltage less than
200mV
is
much accurate and stable than the reading measured in the
Range “ ” .
4.Turn the knob switch
to
“ ” Range.
5.Auto range mode
is
the original states, it displays “ AUTO ” symbol,
Press “ RANGE ” button
to
switch
to
Manual range mode, can select
200mV 、 2V 、 20V 、 200V 、 600V Range.
6 ． Connect the test leads
to
the tested point, the voltage and polarity of
point connected by red lead will be displayed on LCD.
Note
Note
Note
Note
：
1.
At the Manual Range mode, if “ OL ”
is
displayed on LCD, it indicates the
To Next Page
Loading...
