75
OPERATION
Shifting Gears
• Downshifting at a speed in excess of the recommended downshift point may severely damage the
transmission or cause the rear wheel to lose traction. It could also result in engine damage from
running at excessive RPM. Reduce speed before downshifting and do not downshift at a speed above
that in the table of recommended shift points.
• Downshifting abruptly on wet, rough, loose or slippery surfaces can cause the motor cycle to skid.
When downshifting while passing over such surfaces, release the clutch lever very gradually.
• Downshifting in a curve may cause the rear wheel to lose traction. Downshift befor e entering a curve.
WARNING
Recommended Shift Points
The following table shows the appropriate speed at which to shift up or down to each gear.
Upshift (Acceleration)
Gear Change
Upshift Speed
Downshift (Deceleration)
Gear Change
Downshift Speed
1st to 2nd 18 mph (29 km/h) O/D* to 5th 50 mph (80 km/h)
2nd to 3rd 30 mph (48 km/h) 5thto4th 35 mph (56 km/h)
3rdto4th 40 mph (64 km/h) 4thto3rd 25 mph (40 km/h)
4thto5th 50 mph (80 km/h) 3rd to 2nd 15 mph (24 km/h)
5thtoO/D* 60 mph (97 km/h) 2nd to 1st 10 mph (16 km/h)
* 100/6 engine (6 S peed) only
To Next Page