78
OPERATION
Stopping the Engine
Before stopping the engine, bring the m otorcycle t o a complete stop either in neutral or with the clutch disengaged.
Once the motorcycle is at a complete stop, if it is not already in neutral, shift into neutral. To stop the engine, set the
engine stop/run switch to the STOP position, turn the ignition switch t o the OFF position, and remove the ignition
key.
NOTE: Idle air control (IAC) noise is a normal engine management calibration process that occurs each time the engine
stop/run switch is put into the STOP position or when the key is turned off.
• Stopping the engine while the motorcycle is in motion and the transmission is engaged may damage the
engine an d the transmission or cause the rear wheel to lose traction. In either case, you may lose
control.
• If the motorcycle is in motion and the engine stops on its own, guide the motorcycle to a safe location
off the road and away from traffic.
WARNING
To Next Page
Loading...
