EasyManuals Logo

Videx 6256 Series Quick Guide

Videx 6256 Series
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
zZz
zZz
zZz
zZz
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
SERVICE BUTTON
PRIVACY FUNCTION
CAMERA RECALL
When the
system is in
standby
When the
system is in
standby
CALL TONE VOLUME ADJUSTMENT BRIGHTNESS DISPLAY ADJUSTMENT
During a call, a
conversation or in
camera recall mode
In every
situation
In every
situation
During an incoming
call, with the
privacy enabled, the
videophone will not
ring and no picture
will be displayed.
To set up the function of the service button, please
contact Videx Technical.
Press the privacy button to enable the privacy
function. The LED behind the privacy symbol
will
illuminate to indicate that the privacy is enabled.
The privacy function will automatically switch OFF
after the programmed time expires or by pressing the
privacy button
again.
When the conversation
time (set up during the
installation) has ended,
the videophone stops
all communication and
the system returns to the
standby condition.
Push the service button to activate the secondary
service (if this was set up during the installation).
Move the switch, under the call tone symbol to
adjust the call tone volume level. Move to the left for a
low call tone level, to the centre for a medium call tone
level and to the right for a high call tone level.
Turn the roller under the brightness control symbol
to adjust the brightness of the picture. Any
adjustment to the left will reduce the brightness and
any adjustment to the right will increase the brightness.
During 'Camera Recall' it is possible:
To start a conversation;
To push the lock button
to open the door;
To push the service button
to activate the
secondary service.
Hang up the handset to end the conversation.
Pick up the handset and then push the camera recall
button
as many times as the ID value of the door
panel (e.g. if recalling the picture from door ID 2, press this
button twice, for door ID 3 press this button 3 times etc.).
The videophone display will show the picture from the
camera on the relevant outdoor station recalled.
All manuals and user guides at all-guides.com

Other manuals for Videx 6256 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Videx 6256 Series and is the answer not in the manual?

Videx 6256 Series Specifications

General IconGeneral
BrandVidex
Model6256 Series
CategoryIntercom System
LanguageEnglish

Related product manuals