General notice (liability): the details of this technical documents serve for description. Consents regarding the availability of certain features or regar-
ding a certain purpose always require a special written agreement.
GB
Right reserved to make technical changes!Page 47 GB
5.3 Power supply connection and commissioning
Attention!
The electrical power supply should first be connected at
commissioning - Risk of life!
Work on the power supply connector and protection devices
must be carried out by a specialist company, in accordance
with IEC 364, local regulations and the connection conditions
of the respective energy supply company!
Insert the mains plug into a properly grounded outlet with
personal protection measures (fault current circuit breaker)
according to the specification plate.
Electronic regulation
The equipment starts up after self testing the regulation.
A warning signal sounds upon ramping up the regulation.
Unless other selection is made during ramp-up, the regulation
continues with the status which was set before discontinu-
ation of the power supply. I. e. if regulation was in a cooling
mode, it continues in the same mode. If it was in standby, it
will remain in that mode.
To Next Page