11
Range
The range of WLAN connections can be reduced by
walls, ceilings and interior fixtures. These weaken the
WLAN signal, which may result in poor reception.
Range reduction:
■
On their way between transmitter and receiver,
WLAN signals are damped, e.g. by air or when pen-
etrating walls.
■
WLAN signals are reflected by metallic objects e.g.
reinforcements in walls, metal foil of thermal insula-
tion and thermal glazing with metallised thermal
vapour deposit.
■
WLAN signals are isolated by service ducts and lift
shafts.
■
WLAN signals suffer interference from appliances
that also operate with high frequency signals,
such as computers, audio and video systems, wire-
less signals, electrical transformers and pre-ballast.
Distance to such appliances min. 2 m.
Installing the wall mounting bracket
Only install inside enclosed buildings.
!
Please note
The installation site must be dry and free from
the risk of frost.
Ensure ambient temperatures between
−
5 and
40 °C.
Fig. 3
Installation sequence
Installation location (cont.)
5785 665 GB
Installation
To Next Page
Loading...
