20
Setting time phases
Explanation of the procedure using the example of
room heating
You can set up to 4 time phases in each "Time pro-
gram".
For each time phase, you define the start point
"START" and the end point "END".
Example:
"Time program" for "Monday"
■
Time phase 1:
06:30 to 12:00 with the normal room temperature
■
Time phase 2:
15:00 to 20:00 with comfort room temperature
In between these time phases the rooms are heated
with the reduced temperature .
Press the following buttons:
1.
2. / for "SCHEDULE"
3. OK to confirm
4. / for a group of days or a single day
"MO-FR" Set the same time phase for all days.
"SA-SU" Set the same time phase for all days
of the weekend.
"MO-SU" Set the same time phase for all days.
, ... Set the time phase for individual
days.
The days are shown in abbreviated
form or as numbers. To change the
type of display, see page 25.
How the days of the week are shown:
5. OK to confirm
Changing time phase 1:
If you want to start changing another time phase, use
/ to select it and confirm with OK.
01. / to set the hour for the start of the time
phase ("START") to 6.
02. OK to confirm.
03. / to set the minutes for the start of the time
phase ("START") to 30 minutes.
04. OK to confirm
05. / for the required temperature level
"NORMAL"
06. OK to confirm
07. / to set the hour for the end of the time
phase ("END") to 12.
08. OK to confirm.
09. / to set the minutes for the end of the time
phase ("END") to 00 minutes.
10. OK to confirm
Setting new time phase 2:
01. / to set the hour for the start of the time
phase ("START") to 15.
02. OK to confirm.
03. / to set the minutes for the start of the time
phase ("START") to 00 minutes.
04. OK to confirm
05. / for the required temperature level
"COMFORT"
06. OK to confirm
07. / to set the hour for the end of the time
phase ("END") to 22.
08. OK to confirm.
09. / to set the minutes for the end of the time
phase ("END") to 00 minutes.
10. OK twice to confirm
Finalising the time phase settings:
If a setting is not made for all possible time phases, the
first time phase that is not used must be set to "--:--".
Only then are the time phase settings finalised
1. / to set the hour for the start of the time
phase ("START") to --:--.
2. OK twice to confirm.
Using the remote control
Procedure for setting a time program (cont.)
6192459
Operation
To Next Page
Loading...
