Viessmann VITOTRONIC 200 - Page 43

43
Setting "Intensive operation" for ventilation
1. Extended menu:
2. "Ventilation"
3. "Intensive operation"
Mechanical ventilation with maximum air flow rate
(
4
)
Display in the standard menu
40°CFlow temperature
HC1
14°C
21°C
4
4
Fig. 25
Ending "Intensive operation"
You have switched on "Intensive operation" at the
heat pump control unit:
■
"Intensive operation" ends automatically after
2 hours. Your contractor can adjust this duration.
or
■
Set "Intensive operation" to "OFF".
You have switched on "Intensive operation" using an
external switch/button (bathroom switch):
■
"Intensive operation" ends automatically after
30 minutes. Your contractor can adjust this duration.
or
■
Set "Standby mode" for ventilation: see chapter
"Activating standby mode".
Note
If "Intensive operation" ends automatically, operation
continues in the operating program that was active
before "Intensive operation" began.
Energy saving function "Economy mode"
Selecting "Economy mode" for ventilation
1. Extended menu:
2. "Ventilation"
3. "Economy mode"
Mechanical ventilation with minimum air flow rate (
1
)
Display in the standard menu
40°CFlow temperature
HC1
14°C
21°C
1
1
Fig. 26
Mechanical ventilation
Comfort function "Intensive operation"
5790940