10ViewSonic PJ588D/PJ568D/PJ508D
SETUP AND OPERATION
Inserting the Remote Control Batteries
1.
Remove the battery compartment cover
by sliding the cover in the direction of
the arrow.
2.
Insert the supplied batteries taking note
of the polarity (+/-) as shown here.
3.
Replace the cover.
Caution:
Only use AAA batteries.(Alkaline battery is better).
Dispose of used batteries according to local ordinance regulations.
Remove the batteries when not using the projector for prolonged periods.
http://www.pureglare.com.au
To Next Page
Loading...
