23 ViewSonic PJ588D/PJ568D/PJ508D
Advanced Feature
Press the Menu button to open the OSD menu. Press
to move to the Setup menu. Press
to move to the Advanced Feature menu and then press Enter or . Press
to move
up and down in the Advanced Feature menu. Press to change values for settings.
ITEM DESCRIPTION DEFAULT
User Color
This feature adjusts the color balance in each color of RGB (red, green, blue),
and their neutral colors (cyan, magenta, yellow, white) by using color correction
adjustment. Increasing a color’s setting heightens the intensity of that color on
the screen, while a lower setting makes the color less intense.
Press
to select a color.
Press
to adjust the selected color. (Range: 0 – 100)
80
White
Peaking
White Peaking increases the output in the brightest whites without changing the
blacks and dark grays. It crushes the whites slightly, but it does not appear to
clip them or seriously obscure white detail. If you prefer a stronger image, adjust
toward the maximum setting. For a smoother, more natural image, adjust toward
the minimum setting.
Press
to adjust the value of white peaking. (Range: 0 – 10)
Data source:
10
Video
source: 2
Logo
Display
Press
to enable or disable logo display when the projector starts, or when
no source is detected (Range: On – Off)
On
Fan Speed
Press the cursor button to toggle between Normal and High fan speed
Normal
Note
:
When altitude is over 5000 feet, fan speed must be changed to high fan speed.
http://www.pureglare.com.au
To Next Page
Loading...
Need help?
General
