38ViewSonic PJ588D/PJ568D/PJ508D
2.To ensure the problem is not caused by a connected PC’s video card, connect to another
computer.
Problem: The image is at with no contrast
Ad
just the Contrast se
tting on the Main menu of the OSD.
Problem: The color of the projected image does not match the source image.
Ad
just the Color Temperature and Gamma se
ttings on the Main menu of the OSD.
Lamp Problems
Problem: There is no light from the projector
1.Check that the power cable is securely connected.
2.Ensure t
he power source is good by testing with another electrical device.
3.Restart t
he projector in the correct order and check that the Power LED is green.
4.If y
ou have replaced the lamp recently, try resetting the lamp connections.
5.Replace t
he lamp module.
6.Put t
he old lamp back in the projector and have the projector serviced.
Problem: The lamp goes off
1.Power surges can cause the lamp to turn off. Press the power button twice to turn off the
projector. When the Lamp Ready LED is on, press the power button.
2.Replace t
he lamp module.
3.Put t
he old lamp back in the projector and have the projector serviced.
Remote Control Problems
Problem: The projector does not respond to the remote control
1.Point the remote control towards the remote sensor on the projector.
2.Ensure t
he path between remote and sensor is not obstructed.
3.Turn o
ff any fluorescent lights in the room.
4.Check t
he battery polarity of the remote control.
5.Replace t
he batteries.
6.Turn o
ff other Infrared-enabled devices in the vicinity.
7.Have t
he remote control serviced.
http://www.pureglare.com.au
To Next Page
Loading...
Need help?
General
