Remote Control Keys Description (Detailed description refer to SW Specification)
IR-Key Name Detailed Description
3
If there is OSD menu, user can press this key to move to the left item
4/
1. When user press the bottom once, it will enter “Panel Key Lock” setting;
2.When panel key is locked, user could press this key for once to release Panel
Key Lock
3. When there is OSD menu, user can press this key to move to right item
▲/ KEYSTONE +
1. When user presses this bottom once, it will increase the keystone value
2. When there is OSD menu, user can press this key to move to upper item
▼/ KEYSTONE -
1. When user presses this bottom once, it will decrease the keystone value
2. When there is OSD menu, user can press this key to move to next item
Source
1. When Quick Auto Search is "on", user press this key to call out Source OSD
and then press ▲▼ to select source. After pressing Enter key, system would
search all signals from selected source and then project first detected source
within 2~3 seconds.
2. When Quick Auto Search is "off", user could press this key to call out Source
OSD to select search source. After pressing "Enter" key, system would keep
searching selected source
Power
1. User presses this key once to turn on projector
2. When projector is on, user should press this key once and show confirm
message; then user should press "Power" key again to turn off projector (LED
would be blink orange)
Auto
Auto adjusts the most suitable frequency, phase, for the input source. User
could get the optimal projection quality by pressing the button. Auto-Adjustment
function will not influence the color or brightness setting by users. “Auto” will not
be active under video input, including video, S-video and Y/Pb/Pr. The current
source info will be displayed at the bottom right of the screen for 3 seconds after
users press Auto
Blank
1. When user presses the bottom once, the image would turn to blank and show
"blank" in the right-bottom of screen
2. When the image is blank, user press this key back to normal image
Mode/Enter
1. When there is no OSD menu, this bottom is Mode hot key; user would press
this bottom to choose one of preset modes
2. When there is confirm message, user could press this key to confirm
Menu/Exit
1. User could press this bottom to call out OSD
2. When it exits OSD, user could press this bottom to leave current page or
items or to close OSD.
Freeze
This is for "freeze" and "unfreeze". The image will be frozen when the FREEZE
button is pressed. FREEZE is released when Source button (when the input
source is switched over during display ) , FREEZE button again is pressed (the
background sounds will be kept unless user press Mute key)
Digital Zoom +
1. By pressing “Zoom in” button, the center of the picture can be magnified
gradually.
2. When users press this button again, more magnification will take place
gradually
Confidential - Do Not Copy
PJD5122
ViewSonic Corporation
To Next Page
Loading...
