7 Chromatic
aberration
Follow engineering specification
8 Printing Printing must not have incomplete printing, break off, overlap,
uneven thickness, excessive ink, printing misalignment (1.5mm),
printing slanting & crooked (<0.5mm)
Printing color must be comparable to color chip and sample.
Follow engineering specification
9 Logo of panel
sticker
Printing must not have incomplete printing, break off, overlap,
uneven thickness, excessive ink, printing misalignment (1mm),
printing slanting & crooked (<0.5mm)
Printing color must be comparable to color chip and sample.
10 Scratch/Nicks Side A:
(W < 0.1mm , L < 5mm): Only 2 this kind of scratch is accepted
W < 0.1mm , L < 5-10mm :Only 1 this kind of scratch is accepted
Side B:
W < 0.2mm , L < 5mm : Only less than 2 this kind of scratch is
accepted
W < 0.2mm , L < 5-10mm : Only 1 this kind of scratch is accepted
Side C:
W < 0.3mm , L < 5mm : Only 3 this kind of scratch is accepted
W < 0.3mm , L < 5-10mm : Only 2 this kind of scratch is accepted
W < 0.3mm , L < 10-15mm: Only 0 this kind of scratch is accepted
Note:
1. Severe scratch which disclose the Natural
2. When light scratching on it, there’s no feeling of obstruction.
Also, there should not be obvious difference in gloss nearby it.
3. Each scratch should be 5cm more far away from each other
4. Front case must be no any scratch
Confidential - Do Not Copy
PJD5122
ViewSonic Corporation
To Next Page
Loading...
