ViewSonic PJD5122 - Page 96

2. Characteristics of inputs/outputs
Signal Parameter Min Type Max
Impedance 75 Ohm
Amplitude 0.7 Volts peak-to-peak
Black pedestal 0 Volts
RDATA
GDATA
BDATA
Pixel Clock 165 M Hz
Impedance 75 Ohm
Amplitude 1 Volts peak-to-peak
Video amplitude 0.7 Volts peak-to-peak
Sync amplitude 0.3 Volts peak-to-peak
Black pedestal 0 Volts
GDATA_SO
G
Pixel Clock 165 M Hz
Impedance 1 K ohm
Amplitude, low level 0 0.5 volt
Amplitude, high level 2.5 5 Volt
HDATA
Frequency 24 99 K Hz
Impedance 1 K ohm
Amplitude, low level 0 0.8 volt
Amplitude, high level 2.5 5 Volt
VDATA
Frequency 48 120 Hz
Amplitude, low level 0 0.8 volt SDADATA
Amplitude, high level 2.5 5 Volt
Amplitude, low level 0 0.8 volt SCLDATA
Amplitude, high level 2.5 5 Volt
RXD Amplitude -25 25 Volt
TXD Amplitude -13.2 13.2 Volt
Amplitude, total (video+
sync)
1 Volts peak to peak
Amplitude, video 0.7 Volts peak to peak
Amplitude, sync 0.3 Volts peak to peak
CVBS
Luminance
Impedance 75 ohm
Amplitude 300 m Volts peak to peak CVBS
Chroma
Impedance 75 ohm
Audio Impedance (audio in) 40 50 60 Kohm
Amplitude (audio in) 500 Volts rms
Bandwidth 300H
z
16kH
z
S/N Ratio 40 %
Total Harmonic
Distortion
10 %
Confidential - Do Not Copy
PJD5122
ViewSonic Corporation
95