32
i. These buttons function the same as the ones on the OSD menus or remote
control.
ii. To switch input source, click on your desired signal.
Important
• The Menu button can also be used to go back to previous OSD menu, exit and save
menu settings.
• The source list varies according to the connectors available on the projector.
• When you use the projector control panel or remote control to change the OSD menu
settings, it may take a while for the web browser to synchronize these changes with the
projector.
2. The tools page allows you to manage the projector, configure the Lan control
settings and secure access of remote network operation on this projector.
i. This section is only used with the Crestron Control System. Please contact
Creston or refer to its user manual for setup information.
ii. You can name the projector, keep track of its location and the person in charge
of it.
iii. You can adjust the Lan control setting.
iv. Once set, access to the remote network operation on this projector has been
password-protected.
v. Once set, access to the tools page has been password-protected.
• To prevent errors, only input the English alphabet and digits on the tools page.
• After making the adjustments, press the Send button and the data will be saved in the
projector.
vi.Press exit to go back to the Crestron remote network operation page.
Please pay attention to the limitation of input length (including space and other
punctuation keys) in the list blow:
Category Item
Input-Length
Maximum Number of Characters
Crestron Control
IP Address 15
IP ID 2
Port 5
Projector
Projector Name 10
Location 9
Assigned To 9
iv
iii
v
vi
ii
i
To Next Page
Loading...
Need help?
General