Operation
Powering on/off the projector
Powering on the projector:
1. Connect the power using the AC adapter and peripheral signal cable(s)
connections.
2. Press to turn on the projector.
The projector takes several seconds or so to warm up.
3. Turn on your source (computer, notebook, DVD, etc.). The projector automatically
detects your source.
• If you are connecting multiple sources to the projector simultaneously, press
MENU on the projector or Source on the remote control to select your desired
signal or press your desired signal key on the remote control.
Warning
• Never look into the lens when the LED light is on. This can damage your eyes.
• This focal point concentrates high temperature. Do not place any object near it to avoid
possible fire hazard.
Powering off the projector:
1. Press to turn off the projector. You will see a message "Power off? Press Power
again" appear on the screen.
2. Press again to confirm.
3. Disconnect the power cord from the wall socket if the projector will not be used in
an extended period of time.
20
To Next Page
Loading...
