ViewSonic PLED-W200 - Menu Operation

Menu operation
The projector has multilingual on-screen display menus that allow you to make image
adjustments and change a variety of settings.
*1 It is only available when Color Mode is set to User1 or User 2.
*2 It is only available when Auto Keystone is set to Off.
*3 It is only available under computer mode.
*4 It is only available under video mode.
*5 It is only available when no source is connected.
Video/Audio
-5 - +5
Color Temp.
Red Gain
Green Gain
Blue Gain
User, LOW, MID, HIGH
0 - 100
0 - 100
0 - 100
Auto, 4:3, 16:9, 16:10
Overscan*4
Noise Reduction*4
Video Setting*4
Speaker Volume
Mute
-6 - +6
-6 - +1
2% - 10%
Off, LOW, MID, HIGH
Saturation
Sharpness
Tint
0 - 10
Auto Keystone
0 - 4
0 - 100
0 - 31
0 - 100
Computer
Composite
USB
SD Card
Source
Color Mode
Setting
High Altitude
OSD Transparency
Front Table, Front Ceiling,
Rear Table, Rear Ceiling
Off, 1-60 Min
Top-Left, Top-Right, Center,
Bottom-Left, Bottom-Right
5-60 sec.
Off, 10%~90%
LED Calibration*5
Message
Change Password
Password Delete
-5 - +5
On, Off
Off, CC1, CC2, CC3, CC4, T1, T2
Information
Factory Default
Input Source
LED Hours
LED Hours Reset
Computer, Composite,
USB, SD Card
Brightness*1
Contrast*1
Color Setting*1
Gamma*1
Keystone*2
Frequency*3
Tracking*3
H Position*3
V Position*3
Black, Blue, Gray, Red, Green,
Yellow, Cyan, Magenta, White
23