48
SETTING | Network
Network State
Display the network connection status.
DHCP
Use this function to select your desired startup screen. If you change the setting
from one to another, when you exit the OSD menu, the new setting will take effect
on next open.
`
On: Assign an IP address to the projector from an external DHCP server
automatically.
When making a connection in the local area network.
1. Connect the computer and the projector to your network.
2. Press the ‘menu’ key in the remote controller.
3. Select Setting -> Network -> DHCP (as following).
4. DHCP mode selects ‘On.’
If IP Address is 0.0.0.0, please check the connection and try again.
If still can not get the IP Address, please contact your network administrator.
`
Off: Assign an IP address manually.
IP Address
Select an IP address.
Subnet Mask
Select subnet mask number.
To Next Page
Loading...
