ViewSonic SC-T47 - Configuring the Access Privileges and Password of Viewsonic Client Setup

Conguring Client Settings
Conguring System Settings
31
4.2.3 Conguring the Access Privileges and Password of ViewSonic Client Setup
You can congure the access privileges of ViewSonic Client Setup for client users by the Password setting.
Setting Access Privileges and Password Only for Administrators
To set access privileges and password only for administrators, please do the following:
NOTE
• System administrators (and only administrators) are allowed to access ViewSonic
Client Setup by default. If you don’t enable user authentication for administrators
and don’t set a password here, the system administrator privileges are sucient to
access ViewSonic Client Setup. If authentication is enabled and the password is set,
administrators will need that password to enter ViewSonic Client Setup.
1. On ViewSonic Client Setup, click System > Password.
2. Under the Administrator section, click to check Active Admin Authorization.
3. The access privileges for administrators are granted and a window appears for you to set the password.
4. Type in the desired password, and then click Save to apply.
5. Click Save to store all the changes.